Mend it
Most things are thrown away for a small fault: a button, a hole, a gasket, a loose joint. These are the repairs anyone can do at a kitchen table, with a needle, a cloth or a screwdriver.
Clothes and shoes
Sew a button back on 10 minutes
You need: Needle, Thread close to the colour of the old thread, The button (or a spare from the label).
- Cut about an arm's length of thread, thread the needle and knot the two ends together so you sew with a double strand.
- Push the needle up from the back of the fabric where the old button sat; the old holes usually show.
- Go up through one hole of the button and down through the opposite one, 6 to 8 times. Lay a pin across the top of the button as you sew, so the stitches stay a little loose.
- Pull out the pin, come up under the button, and wind the thread round the stitches three or four times to make a short shank. This is what stops buttons tearing off again.
- Push the needle to the back, make two small stitches through the threads there, and cut.
Do it the day the button comes off, while you still have it.
Darn a hole in a wool sock 20 minutes
You need: Darning needle (large eye, blunt tip), Wool yarn close in weight to the sock, Something round to stretch it over: a darning mushroom, a light bulb or an orange.
- Stretch the hole over the round object, without pulling it tight.
- Starting in solid knitting a little to one side of the hole, sew rows of running stitches across, back and forth, covering the hole and a margin of healthy fabric around it.
- Turn the sock a quarter turn and weave a second set of rows through the first: over one, under one, like a tiny piece of cloth.
- Leave the yarn ends a few centimetres long on the inside rather than knotting them; they work in with wear.
Catch thin patches before they become holes: darning a worn spot takes half the time.
Patch a hole in jeans 30 minutes
You need: A piece of denim or sturdy cotton larger than the hole, Needle and strong thread, Pins.
- Trim loose threads from the hole, but don't cut it bigger.
- Turn the jeans inside out and pin the patch over the hole, with a margin of at least 2 cm all round.
- Turn them right side out. With small running stitches, sew rows back and forth over the hole and the area around it, through both layers. Rows a few millimetres apart hold best.
- Sew round the edge of the patch on the inside to stop it lifting.
Visible mending, in a contrasting thread, is part of the look; nobody needs to pretend it never happened.
Re-wax a waxed cotton jacket or bag 1 hour, plus a day to dry
You need: A tin of wax dressing for waxed cotton, A bowl of hot water to warm the tin, A sponge or soft cloth, A hairdryer.
- Sponge the jacket clean with cold water and let it dry completely. Never use detergent.
- Stand the tin in hot water until the wax is soft and creamy.
- Work the wax into the fabric with the cloth in small circles, paying most attention to seams, shoulders and elbows.
- Go over it gently with a hairdryer so the wax soaks in and the finish evens out.
- Hang it somewhere warm overnight before wearing.
Once a year is plenty for most jackets; do it when the cotton starts to look pale and dry.
For: Barbour Bedale waxed cotton jacket · Fjällräven Greenland winter jacket · Fjällräven Kånken backpack
Make a waterproof jacket bead again 2 hours, mostly waiting
You need: A technical wash made for waterproofs, A spray-on or wash-in reproofer.
- Close all zips and wash the jacket on a cool synthetic cycle with the technical wash. Don't use fabric softener or ordinary detergent.
- Tumble dry on low if the label allows. Heat often brings the water repellency back on its own.
- If water still soaks in rather than beading, spray the reproofer evenly over the outside while the jacket is damp, then dry it again on low.
Dirt and oil are usually the problem, not a worn-out jacket. Wash it before deciding it has failed.
Clean and condition leather boots 20 minutes
You need: Stiff brush, Damp cloth, Leather conditioner or oil suited to the leather.
- Take out the laces and brush off dried mud, especially around the welt where upper meets sole.
- Wipe the leather with a damp cloth and let it dry at room temperature, never next to a radiator.
- Rub in a thin layer of conditioner with your fingers or a cloth, working into creases.
- Leave it to soak in for an hour, then buff off any excess.
When the sole wears thin, take welted boots to a cobbler before it wears through to the midsole; resoling is far cheaper than new boots.
Free a stuck or stiff zip 5 minutes
You need: A graphite pencil, a bar of soap or a little candle wax, Tweezers, if fabric is caught.
- If fabric is caught in the slider, work it out gently with tweezers, pulling the fabric away from the teeth rather than yanking the slider.
- Rub the pencil lead, soap or wax along both rows of teeth either side of the stuck slider.
- Move the slider back and forth in short strokes until it runs freely, then wipe off any excess.
- If the zip closes but splits open behind the slider, the slider has worn loose. A cobbler or tailor can fit a new slider for much less than a new zip.
Most “broken” zips are only dirty or dry. Try this before anything else.
For: Fjällräven Kånken backpack · Patagonia Torrentshell 3L rain jacket · Osprey Farpoint 40 travel pack · Fjällräven Greenland winter jacket
Bring a pilled jumper back 15 minutes
You need: A fabric shaver, a wool comb or a new disposable razor, A flat surface.
- Lay the garment flat on a table and smooth it out without stretching it.
- Hold the fabric taut with one hand and run the shaver or comb lightly over the bobbles in one direction.
- Use short, gentle strokes with no pressure; the aim is to lift the pills off, not to thin the knit.
- Shake it out and fold it. Store wool folded, not on a hanger, so it keeps its shape.
Pilling is loose fibre working to the surface, not a fault. It slows down after the first few washes.
For: Icebreaker merino wool T-shirt · Patagonia Better Sweater fleece jacket
Patch a small tear in a jacket 5 minutes
You need: Self-adhesive repair tape for outdoor fabric, Scissors, Rubbing alcohol and a cloth.
- Push any escaping down or insulation back inside; don't pull it out, or the hole grows.
- Clean the area around the tear with a little alcohol and let it dry.
- Cut a patch at least 1 cm bigger than the tear on every side, and round the corners so they don't lift.
- Press it on firmly from the centre outwards and rub it for a minute. Let it set before wearing.
Many outdoor brands repair their own jackets properly. For a big tear, ask them before patching.
For: Patagonia Torrentshell 3L rain jacket · Fjällräven Greenland winter jacket
Kitchen
Bring back a rusty cast iron pan 1.5 hours
You need: Steel wool or a stiff scourer, Washing-up liquid, Neutral cooking oil, Kitchen paper, Oven.
- Scrub off all the rust with steel wool and a little soapy water, down to grey metal. This is the one time soap and hard scrubbing are fine.
- Rinse, dry thoroughly, then put the pan on a low hob for a few minutes so every bit of water is gone.
- Rub a very thin coat of oil over every surface, inside, outside and handle, then wipe it off as if you made a mistake. What's left is enough.
- Bake it upside down at about 230°C (or as hot as your oven goes) for an hour, with a tray below. Let it cool in the oven.
- Repeat the oil-and-bake once or twice if you want a darker, slicker finish.
Afterwards: rinse, dry on the heat, a few drops of oil. That's all it ever needs.
For: Lodge cast iron skillet, 10.25 inch · de Buyer Mineral B carbon steel frying pan, 28cm
Sharpen a kitchen knife on a whetstone 20 minutes
You need: A combination whetstone (a medium grit around 1000 and a fine grit), Water, A damp tea towel to stop the stone sliding.
- Soak or wet the stone as its instructions say and set it on the damp towel, medium side up.
- Hold the knife at a low, steady angle, roughly the height of two stacked coins under the spine.
- Push the blade across the stone edge-first, sweeping from heel to tip, 10 to 15 times on one side, until you can feel a slight burr along the other side of the edge.
- Repeat on the other side, then do the same on the fine side with lighter strokes.
- Finish with a few alternating light strokes per side, then wash and dry the knife.
Between sharpenings, a few strokes on a honing steel every few uses keeps the edge straight.
For: Victorinox Fibrox Pro chef's knife, 8 inch · Opinel No.8 folding knife
Replace a moka pot gasket 5 minutes
You need: A replacement gasket (and filter plate) for your pot's size, A small flat screwdriver or butter knife.
- Unscrew the pot and remove the funnel.
- Prise out the old rubber gasket and the metal filter plate from inside the top half. Old gaskets are often hard and come out in pieces.
- Clean the groove of any coffee residue.
- Press the filter plate back in, then the new gasket on top, pushing it evenly all round until it sits flat.
If coffee leaks from the middle or the pot hisses and spits, the gasket is the reason nine times out of ten.
Descale a kettle 30 minutes
You need: White vinegar or citric acid, Water.
- Fill the kettle halfway with equal parts water and vinegar, or water with a couple of tablespoons of citric acid.
- Bring it to the boil, then leave it to stand for 20 minutes.
- Pour it away, rinse well and boil a kettle of clean water once before using it for drinks.
In a hard-water area, doing this monthly keeps the kettle efficient and stops flakes in your tea.
Oil a wooden chopping board or spoon 10 minutes, plus overnight
You need: Food-safe mineral oil or a board oil, A clean cloth.
- Wash and dry the board completely.
- Pour a little oil on and rub it in with the cloth, along the grain, on all sides.
- Leave it overnight to soak in, then wipe off anything left on the surface.
Avoid cooking oils like olive or sunflower, which can go rancid in the wood.
Replace a French press filter 5 minutes
You need: A replacement mesh filter for your press size.
- Unscrew the plunger rod from the filter assembly; it usually turns anticlockwise.
- Separate the layers (spiral plate, mesh, cross plate) and note their order.
- Swap in the new mesh, rebuild the stack in the same order and screw it back on.
- Once a month, take the filter apart like this and wash out the trapped oils; it keeps the coffee clean.
Grounds in the cup usually mean a bent or worn mesh, not a broken press. The glass jug is sold on its own too.
Home and tools
Fix a wobbly chair 15 minutes to a day
You need: Screwdriver or multi-tool, Wood glue (for loose joints), A strap or rope to clamp.
- Turn the chair over and find what moves. If there are screws or bolts, tighten them first; often that's all it needs.
- If a glued joint is loose, gently work it apart, scrape off the old glue, and apply fresh wood glue.
- Push it back together and hold it tight with a strap or rope twisted with a stick, overnight.
- If one leg is simply shorter, a felt pad under it is a fine, honest fix.
Most furniture is thrown out for a loose joint that takes ten minutes and a bottle of glue.
For: Leatherman Wave+ multi-tool · Victorinox Huntsman Swiss Army knife
Clean and oil a folding knife or multi-tool 10 minutes
You need: Warm water and a drop of washing-up liquid, An old toothbrush, Light oil.
- Open every blade and tool. Brush out the pivots and the inside of the handle with warm soapy water.
- Rinse and dry completely; leave it open somewhere warm for an hour.
- Put one drop of oil on each pivot and work it open and shut a few times. Wipe off the excess.
A wooden-handled knife shouldn't soak; wipe the blade instead and keep the handle dry.
For: Opinel No.8 folding knife · Leatherman Wave+ multi-tool · Victorinox Huntsman Swiss Army knife
Flush a fountain pen that won't write 15 minutes, plus drying
You need: A glass of cool water, Kitchen paper, A converter or a bulb syringe (optional).
- Remove the cartridge or converter and stand the nib section in a glass of cool water for an hour.
- Flush water through it, with the converter or by holding it under a gently running cold tap, until the water runs clear.
- Wrap it in kitchen paper, nib down, and let it dry overnight before refilling.
Pens left unused with ink inside are what clog. If you won't write for a few weeks, flush it first.
For: LAMY Safari fountain pen · Kaweco Classic Sport fountain pen
Change the battery in a simple quartz watch 15 minutes
You need: A small cross-head or flat screwdriver for the case back, The right coin cell (it is printed on the old one), Something plastic to lift the cell, such as a toothpick.
- Lay the watch face down on a soft cloth. Undo the screws on the back and keep them in a dish.
- Lift off the back. Note which way up the old cell sits, and any small metal clip that holds it.
- Ease the old cell out with something plastic rather than metal, and put the new one in the same way up.
- Check the seal is seated, refit the back and set the time. Take the old cell to a battery recycling point.
If the watch has a rubber gasket under the back, a thin smear of petroleum jelly helps keep water out.
Find someone who can fix it 5 minutes
You need: The broken thing.
- Search for a repair café near you: volunteers fix electricals, clothes, bikes and furniture for free, and show you how.
- For shoes, bags, zips and keys, a local cobbler can do more than most people expect.
- Check the maker: many of the brands we recommend repair what they sold, sometimes for free.
- For electronics, look up the model on a repair guide site before deciding it's beyond saving.
Ask before you replace. The question costs nothing.
To go further with clothes, Mending Matters is a good, practical book on patching and darning.
Looking for everyday care instead of repairs? Keep it going has notes for everything we recommend.